Call us on – 0844 412 2242
Ironmongery Online

In the trade?
Basket
 
 
 
 
 
 
 
 
 

» print this guide...

Hang Wallpaper – Internal and External Corners.

So far, so good! We’ve prepared properly; we have the first lengths of new paper up; and it’s looking great- so far- but now we come to the corners, the awkward bits. . Skill rating : Intermediate

Introduction...
Hang Wallpaper – Internal and External Corners.

 

So far, so good! We’ve prepared properly; we have the first lengths of new paper up; and it’s looking great- so far- but now we come to the corners, the awkward bits. Actually, they aren’t that hard. We need to just take our time here; corners stick out, or inwards, and are a focal point for our eyes! Mistakes here tend to stick out like a sore thumb; so just follow the steps below, and you shouldn’t have too much trouble.
 
Corners are rarely square and true, and simply hanging the wallpaper without taking this fact into consideration can lead to big problems as the strips are hung. What starts off as a “slight” out of trueness? Will increase and become more pronounced as we progress. The effect can be awful; as the pattern runs off at an ever increasing angle.

 

 

The best way to tackle internal corners is to paper towards the internal corner, but stop at the last full length (and roll width)of wallpaper you’ve hung before the corner, then measure the short gap (something less than the roll width) at the top and bottom. Add about 10-15mm extra to return the paper in and around the corner.
 
Using a pencil and a straight edge, draw a line on the paper, from top to bottom. The measurement between the top and bottom may vary; but don’t worry; it’ll work out just fine. When you have cut your strip; paste it and allow soaking as before.
 
Brush the paper smooth and flat with the cut edge firmly pressed into the angle of the corner, so the slight overlap returns onto the adjoining wall.

Internal Corners.

Internal Corners.
 

Now, before hanging the next strip (on the wall adjoining the corner) deduct the same measurement you overlapped by; 10-15mm, or whatever you overlapped by, and mark a new plumb line on the wall at this point. Hang this next strip by butting the edge of the paper against the new line, and return the extra bit round the corner onto wall you’ve just finished.

Before hanging the next strip.

Before hanging the next strip.
 

Again, using the scissors, mark a line down the angle of the corner to mark your cut-line. When done, peel back and trim. You may need to add a bit more adhesive to allow slide-ability and to stick the edges together neatly in the corner, when done, wipe down with a damp sponge or cloth.

Cutting In.

Cutting In.
 

When planning your starting point, consider also external corners. As you offer up a roll of paper at the start of the project; working out how many strips you will need, and where things begin and end, make it so the last full strip before a corner overlaps the external corner by approximately 25mm. Paste and allow soaking and then hang the piece in position, overlapping the corner by the 25mm extra you have allowed. If it starts sticking up at the short edge; then as before – cut short nicks along the edge; this will make it easier to stick down.

External Corners.

External Corners.
 

Next, mark a new plumb line on the wall of the next piece for hanging, but add on about 5mm-6mm. Hang the next strip from the new plumb line with the other edge overlapping by the 5mmor 6mm you have added.

Mark a New Plumb Line.

Mark a New Plumb Line.
 

Hang the strip in position and smooth down as before. Trim both the top and bottom edges, and roll flat with a seam roller, but again, only if the paper is not relief or embossed.
 
Then carry on, till the next obstruction.

Almost Round the Bend.

Almost Round the Bend.
 
What You Need For The Job...
From £41.02
Add to Basket
 
From £4.85
Add to Basket
 
From £3.95
Add to Basket
 
From £1.06
Add to Basket
 
From £1.23
Add to Basket
 
From £3.59
Add to Basket